GE MDS entraNET 900, Technical Manual

Page: 73 / 220

05-4055A01, Rev. E MDS entraNET Technical Manual 63
Invisible place holder
Figure 3-27. Remote Serial Gateway Menu—Initial Screen
•
RSG Talkback Enable
(UDP IP-to-Serial)—When Talkback is
enabled and the RSG is set up for UDP mode, a message
from a Remote radio (usually a reply to a poll) is sent to the
last IP address or port from which a message was received.
[
Enabled, Disabled; Enabled
]
•
RSG Talkback Timeout
—Use this selection to set a time limit
after which, if no data has been received from the IP host, the
RSG talkback feature expires. When this happens, the RSG
reverts to its configured IP address and port for upstream data
destined for an IP host. [
Time in seconds; 30
]
•
RSG Entries
—This selection allows entry of key RSG
parameters including Unit ID, COM port setting, Mode, and
Local IP Port. This screen is shown in
Figure 3-28 on
Page 64 .
•
Remote Serial Wizard
—This tool assists you in adding or
changing a configuration to your remote serial gateway
entries. These are the same settings contained in
RSG Entries
Screen , but the Remote Serial Wizard presents a step-by-step
series of screens with explanatory text to assist you in making
your selections.