INSTALLATION INSTRUCTIONS
Step 12. Connect drain line
Follow all local codes and ordinances.
DRAIN LINE PREPARATION
1. All models are supplied with a pre-attached 78”
long corrugated drain hose. The molded end is
designed to fit 5/8”, 3/4” or 1” diameter connections
to the waste tee or disposer. Cut on premarked line
as required for your installation as illustrated in
Figure Q.
Note:
DO NOT CUT CORRUGATED PORTION
OF HOSE.
Cutting Lines
1"
3/4"
5/8"
Do not cut corrugated
portion of hose
Cut Lines
Figure Q
If the location requires a longer drain hose, add up
to 42” length to the factory installed hose. Use 5/8”
inside diameter hose and thin wall copper coupler
to join the hose ends. Secure connection with
appropriate clamps (not supplied).
Note:
TOTAL DRAIN HOSE LENGTH MUST
NOT EXCEED 10 FEET FOR PROPER DRAIN
OPERATION.
DRAIN LINE INSTALLATION
Connect drain line to waste tee or disposer as
previously outlined in
“Prepare Drain Plumbing”
section of this manual. Refer to Figure S.
Secure connection using appropriate clamps (not
supplied).
Make sure drain hose is not kinked.
16
Verify that power is turned off at sourc
e. If
power cord is used, plug it into the wall outlet and
go to Step 14.
If dishwasher is to be directly wired to house
wiring, continue with this step.
Remove junction box cover.
Secure the power supply cable to the back of the
junction box with a strain relief (not supplied).
Connect incoming wires to dishwasher wires using
wire nuts of appropriate size. Connect incoming
white to white wire, black to black wire and
incoming ground to green wire as shown in
Figure S.
Replace the junction box cover
.
If house wiring is not 2-wire as
shown in Figure S
with a ground
wire,
a ground must be provided by
the installer.
When house wiring is aluminum, be
sure to use UL/CSA. recognized anti-
oxidant compound and aluminum-to-copper
connectors.
CAUTION
WARNING
18”
Min.
18”
Min.
Waste Tee Installation
Dispenser Installation
Step 11. Connect water supply
Connect water supply line
to 90° elbow installed in
Step 4.
90° Elbow
90° Elbow
Door
Spring
Compression Nut
Hot Water
Supply Line
Door Fits
and Swings
Back Behind
Cabinet
Frame
Door Catches
on Cabinet
Frame
Incorrect Alignment
2. Test Door Swing
The edges of the dishwasher door should be behind
the cabinet frame. Carefully open and close the
dishwasher door to ensure the door panel is not
catching or rubbing on the cabinet frame.
3.Correct Alignment If Necessary
If the door catches on the cabinet frame, remove
countertop mounting screws. Reposition the
dishwasher and check to be sure it is level and
centered in the opening. Reinstall the countertop
mounting screws.
Reposition Dishwasher by Grasping
Both Dises With Hands.
Do Not Push Against Front Door
Panel With Knee. Damage to The
Door Panel Will Occur,
Correct Alignment
Step 13. Connect power supply
Ferrule
