6
To install a bracket on each side of each LED light engine, place each bracket on the LED light engine as shown
(left). While pushing back on the tab on the bridge, slide the bracket until the notch on the bridge falls into a slot
on the bracket. Choose which slot depending on desired height of light engine (height can be adjusted after
installation).
NOTE:
Do not remove spacers on the brackets’ screws, as they are meant to stay on screws after installation.
Bridge
9
Ensure bracket
fits in bridge
(2) Move bracket
(1) Push on tab
BRACKETS (A) OR (B):
Insert the LED light engine in the tombstones. Ensure that the pins of the LED light engine are
aligned with the tombstones.
BRACKET (C):
Insert the LED light engine in the tombstones: 1
st
insert the pins on the stationary locking mechanism
into the corresponding tombstone, then slide the adjustable locking mechanism into its corresponding tombstone.
NOTE:
If connecting two 4ft LED light engines to one GE 90W LED driver, ensure that the light engines are oriented
such that the black and red wires of both light engines are next to each other in the center of the fixture, such that
the wires can reach the same connector.
NOTE:
Check that the LED light engine height is as desired. If not, adjust the fixture as shown in previous step. Before
installing the rest of the fixtures, adjust all of the brackets to the same height (can also be adjusted after installation).
10
10A
10B
1) Insert pins into
1
st
tombstone
2) Slide into
2
nd
tombstone
BRACKET (A) OR (B) OR (C):
Lock the LED light engine in the tombstones by turning all locking mechanisms to the
locked position as shown.
11
11A
11B
11C