and blue wires from the driver to the light engine.
housing, please make sure no wires are pinched by the driver box. Connect the quick connector with the red
into the embosses on the light engine housing. Before secure the box with the captive screw to the light engine
the cavity. The green-yellow ground wires should also be fed in to the same hole. Insert the driver box tabs
connector from the light engine should be fed through the square hole on the bottom of the driver box in to
Luminaire Installation
Carefully unpack unit from its packaging. Properly
inspect for defects before installing. Wear work
gloves to prevent dirt and oil from being
transferred to the luminaire.
1
Remove the fixture and driver box from the
package. If a lumen level other than M (medium)
is desired, remove switch cover and set to the
desired lumen level and re-attach cover.
2
L
M
H
2BY2:
2450lm
3750lm
4500lm
2BY4:
3500lm
4550lm
5250lm
Loosen the screw on the driver box cover and open the electrical cavity.The red and blue wires with a
3
Switch
1
2
3
4
2
