GE KTD-405, User Manual, Page: 20 / 76

KTD-405/KTD-405A Controller Keypad
User Manual
16
Connecting new and old I/O boxes
Adhere to all installation guidelines while making connections, including your local codes and those provided
in
Installation guidelines on page 8.
Note: For additional connection details about the old I/O boxes, see Appendix D. Old I/O Box Connections .
Figure 12. New to old I/O box connection
RS-485 shield (float) RS-485 OUT (data out to devices such as multiplexers or
DVMRes; ground at mux/DVMRe)
Note: When using STP for the RS-485 connection
between I/O boxes, you can use only one of the
two RJ45 RS-485 OUT connections to a
multiplexer or DVMRe. This ensures proper
termination.
12 VDC (no polarity on old I/O box)
RJ45 from keypad (RS-422 data in from keypad; silver
crossover cable for old I/O box)
RS-422 IN (data in from devices such as alarm units, ASCII
converters, or keypads (see guidelines))
RS-422 OUT (data out to devices such as domes, switchers,
or keypads (other than KTD-405s)) KEYPAD IN (RS-422 and RS-485 data in from keypad; black
straight-through cable for new I/O box)
12 VDC (observe polarity on new I/O box) PIN 1 to RS-485 shield (ground one end only)
RS-485 to I/O box of additional keypad PIN 3 to RS-485 A
PIN 6 to RS-485 B (PINs 2, 4, 5, 7, and 8 are not connected.)
78
9
10
6
5
3
2
14
POWER 12 VDC
BIAS
SWITCH
78
9
10
6
5
3
2
14
RS485
A
B
A
B
+
AUDIO
KEYPAD
RS485
RS485
A
B
RS422 IN
RS422 OUT
SPEAKER SHIELD
SPEAKER
REMOVABLE TERMINAL STRIP
EARTH GROUND
1 2 3 4 5 6 7 8
Observe polarity for:
• audio
• RS-422
• RS-485
• 12 VDC power. Transformer must have a
positive center-polarity plug
Note: When using multiple
keypads, you
can connect
CyberDom
es and
other
receivers to
the RS-422
output from
any keypad.
A H
B
C
D
E I
F J
G K
L