GE JKS10, Technical Service Manual

Page: 45 / 66

– 45 –
Convection Fan Motor
Note: The resistance of this component can be
tested from the EOC. (See
Control Board Testing
.)
The convection fan motor is located on the back
wall of the oven cavity. The fan motor utilizes a
capacitor that can be accessed from the control
compartment. (See
Component Locator Views
.)
The convection fan operates during the following
modes:
Convection Bake •
Convection Broil •
Convection Roast •
Proof •
Preheat •
Clean •
The convection fan will turn on (after a short delay).
The fan may cycle on and off, and change direction
in any of these modes, to best distribute hot air in
the oven. The convection fan shuts off when the
door is opened.
The convection fan motor has approximate
resistance values between the following wires:
• Red and Blue: 168
Ω
• Red and Gray: 75
Ω
• Blue and Gray: 93
Ω
To remove the convection fan motor assembly:
Remove the convection fan blade. (See 1.
Convection Fan Blade
.)
Remove the oven from the installation and 2.
remove the rear covers. (See
Oven Removal .)
Convection Air fl ow
Disconnect the convection fan motor wire 3.
harness.
Remove the three ¼-in. hex-head screws that 4.
hold the convection fan motor to the back of the
oven.
Disconnect
Meat Probe and Outlet
If equipped, the meat probe outlet is located on
the top of the oven cavity, near the front. The meat
probe outlet is connected to the electronic oven
control. The meat probe has a resistance value of
30K-50K
Ω
at room temperature.
To remove the meat probe outlet:
Open oven door. 1.
Remove the two 2.
1 /
4
-in. hex-head screws that
hold the meat probe outlet to the top of the oven
cavity.
Pull the probe outlet wiring through the wiring 3.
entry hole and disconnect the connector.
Note: Upon reassembly, ensure that the displaced
insulation around the oven and its components is
returned to its original position.
Meat Probe Outlet