8
Safety
Instructions
Operating
Instructions
Car
e
and
Cleaning
Tr
oubleshooting
Tips
Consumer
S
uppor
t
Using the gas surface burners.
Throughout this manual, features and appearance may vary from your model.
How to Light a Gas Surface Burner
Push the control knob down and turn it
to the
LITE
position.
You will hear a little
clicking
noise—the
sound of the electric spark igniting the
burner.
After the burner ignites, turn the knob
to adjust the flame size.
To turn a burner off, turn the knob
clockwise, as far as it will go, to the
OFF
position.
If the flame is too low at the setting,
the valve can be adjusted. Refer to
Flames
too high or too low at the LOW setting
in the
Troubleshooting Tips
section.
Push the control knob down and
turn it to the LITE position.
How to Select Flame Size
For safe handling of cookware, never
let the flames extend up the sides
of the cookware.
Watch the flame, not the knob, as you
reduce heat. The flame size on a gas
burner should match the cookware
you are using.
Any flame larger than the bottom of
the cookware is wasted and only serves
to heat the handle.
If the burner has not been used recently,
the flames may make a loud noise. This is
normal, and it should dissipate after 4 to 5
minutes.
Electric Ignition
Your surface burners are lit by
electric ignition, eliminating the need for
standing pilots with constantly burning
flames.
In case of a power outage,
you
can light the surface burners on your
cooktop with a match. Hold a lit match
to the burner, then turn the control
knob to the high position.
Use extreme
caution when lighting the burners
this way.
Surface burners in use when an
electrical power failure occurs will
continue to operate normally.
IN CASE OF A POWER FAILURE,
THE VENTILATION SYSTEM WILL NOT
OPERATE. DO NOT USE THE GRILL
MODULE OR GRIDDLE IF THE
VENTILATION SYSTEM IS NOT
OPERATIONAL.
Before Lighting a Gas Burner
■
Make sure all grates on the cooktop are
in place before using any burner.
■
Only surface burners may be used
on the right side.
After Lighting a Gas Burner
■
Do not operate the burner for an
extended period of time without
cookware on the grate. The finish
on the grate may chip without
cookware to absorb the heat.
■
Check to be sure the burner you
turn on is the one you want to use.
■
Be sure the burners and grates are
cool before you place your hand,
a pot holder, cleaning cloths or
other materials on them.
■
When trying to simmer delicate foods,
use the right side of the unit for best
results. The
LO
setting on the left side
is hotter to accommodate the grill
module. If you find that the
LO
setting
is too hot, you can adjust the valve.
See the
Troubleshooting Tips
section.
■
Do not allow large pans to extend
over the control knobs. Heat trapped
between large pans and control
knobs could cause possible damage
to the control knobs.
