To Remove the Grill Module:
1. Make sure that all control knobs are set
to
OFF
and all grill components are cool.
2. Remove the grill grate.
3. Lift the grill burner up slightly and pull it
away from the white slotted receptacle
and brass orifices. Lift it out of the basin
when it is completely unplugged.
4. Do not store or stack modules where
they could fall or be damaged.
NOTE:
The optional sealed burner module
JXGB90 can replace the grill burner
assembly.
Surface burner and grill modules.
Throughout this manual, features and appearance may vary from your model.
Safety
Instructions
Operating
Instructions
Car
e
and
Cleaning
Tr
oubleshooting
Tips
Consumer
S
uppor
t
10
Sealed Burner Module
To Install the Sealed Burner Module:
1. Make sure that all control knobs are set
to
OFF
.
2. Clean the cooktop basin to remove any
grease accumulation. See the
Care and
Cleaning the Cooktop
section.
3. With the back of the burner module
tilted up and the two round openings
and three pins facing toward the front,
insert the module in the cooktop basin.
4. Slide the burner module forward until
the pins start to engage the white
slotted receptacle.
5. Lower the back of the module into place
and carefully slide it forward until the
pins are fully engaged.
6. Place the burner caps on the burners.
Carefully place the grate onto
the module with the two tabs
on the underside toward the
center of the cooktop.
To Remove the Sealed Burner Module:
1. Make sure that all control knobs are set
to
OFF
and that the cooktop is cool.
2. Lift up the edge of the burner module
until the bottom of the module clears
the edge of the basin.
IMPORTANT:
Do not lift the module too
high while it is still connected—you could
damage the ignitor rods and mixer
tubes.
3. Hold the module by the sides and pull it
away from the slotted receptacle and
brass orifices. Lift it out of the basin
when it is completely unplugged.
4. Do not store or stack modules where
they could fall or be damaged.
NOTE:
The optional sealed burner module
JXGB90 can replace the grill burner
assembly.
Grill Module
To Install the Grill Module:
1. Make sure that all control knobs are set
to
OFF
.
2. Position the grill burner with the two
round tubes and three pins facing
the front.
3. Slide the grill burner forward until
the pins and ignitors are engaged in
the white slotted receptacle; then
lower the burner until it rests on
the mounting pins.
4. Carefully place the grill grate on
the cooktop. The grate is designed to fit
one way only. See the illustration.
NOTE:
Before using the grill for the first
time, heat the grill burner to remove the
protective shipping coating. Heat the grill
burner on
HI
for 10 minutes and use the
vent system to remove any additional
smoke during cooling.
The grill consists of a black grill grate and the grill burner. Only install the grill on the left side
of your cooktop.
