Problem
Possible Causes
What To Do
“F— and a number
You have a function
•
Press the
Reset/Off
pad. Allow the oven to cool for
or letter” flash
error code.
one hour. Put the oven back into operation.
in the display
If the function
•
Disconnect all power to the oven for at least 30
code repeats.
seconds and then reconnect power. If the function
error code repeats, call for service.
Display goes blank
A fuse in your home may
•
Replace the fuse or reset the circuit breaker.
be blown or the circuit
breaker tripped.
The clock is in the
•
See the
Special features of your oven control
section.
black-out mode.
Display flashes
Power failure.
•
Reset the clock.
Unable to get the
Oven control pads were
•
The
Bake
and
Broil Hi/Low
pads must be pressed
display to show “SF”
not pressed properly.
at the same time and held for 3 seconds.
Power outage,
Power outage or surge.
•
Reset the clock. If the oven was in use, you must reset
clock flashes
it by pressing the
Reset/Off
pad, setting the clock
and resetting any cooking function.
“Burning” or “oily”
This is normal in a
•
To speed the process, set a self-clean cycle for a
odor emitting from
new oven and will
minimum of 3 hours. See the
Using the self-cleaning
the vent
disappear in time.
oven
section.
Strong odor
An odor from the insulation
•
This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
Fan noise
A cooling fan may
•
This is normal. The cooling fan will turn on
automatically turn on.
to cool internal parts. It may run for up to 1-1/2
hours in 30
″
models and up to 2 hours in 27
″
models
after the oven is turned off.
28
Before you call for service…
Troubleshooting Tips
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
Summary of Contents for JCKP30-27
Page 30: ...30...
