34
34
Installation Instructions
INSTALL THE RANGE
ANTI-TIP DEVICE INSTALLATION
ANTI-TIP DEVICE INSTALLATION
(cont.)
LEVEL THE RANGE
3
3
4
A
B
C
D
WARNING:
l
Range must be secured with an approved
Anti-Tip device.
l
Unless properly installed, the range could be
tipped by you or a child standing, sitting or
learning on an open door.
l
After installing the Anti-Tip device, verify that
it is in place by carefully attempting to tilt the
range forward.
l
This range has been designed to meet all
recognized industry tip standards for all
normal conditions.
l
The use of this device does not preclude
tipping of the range when not properly
installed.
Mark the wall where the
RIGHT EDGE
of
the range is to be located. Be sure to allow
for the countertop overhang if you intend to
install the range next to cabinets.
Locate the
outside edge
of the device
2 1/8” toward
the center
of the range
from the
marked edge
of the range.
Using the device as template, mark the
position of the hole for the screw.
For wood construction, drill a pilot hole at
an angle of 20 degrees from the horizontal.
A nail or awl may be used if a drill is not
available.
Install the sleeve anchor into the drilled
hole and then install the lag bolt through the
device. The bolts must be properly tightened
as recommended for the hardware.
Slide the range against the wall, and check
for proper installation by grasping the front
edge of the cooktop and carefully attempting
to tilt the range forward.
For proper cooking and baking, the range
must be leveled. Leveling legs are located
on each corner at the base of the range.
Install the oven shelves
(see Using the oven
section for instructions).
Put a spirit level or a glass
measuring cup partially
filled with water on one of
the oven shelves.
Turn the legs clockwise
to raise the range and
counterclockwise to
lower the range. Adjust
the leveling legs until the
range is level.
Anti-Tip
device
Back of
range
Wallboard
Wood screw
E
A
B
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, you will need
a ¼” x 1 ½”
lag bolt and
a ½” O.D.
Sleeve anchor,
which are
not provided.
Drill the
recommended
size hole for the
hardware.
Summary of Contents for JCAS745
Page 42: ...42 Notes...