SURFACE CONTROLS
At both OFF and HI the control “clicks” into position.
You may hear slight “clicking” sounds during cooking,
indicating the control is keeping the unit at the heat
level or power level you set.
Switching heats to higher settings always shows a
quicker change than switching to lower settings.
How to Set the Controls
Push the knob in
and turn in either
direction to the
setting you want.
Be sure you turn the control knob to OFF when you
finish cooking.
The surface unit “on” indicator light will glow
when ANY surface unit is on.
Cooking Guide for Using Heat Settings
HI—Used to begin cooking or to bring water to a
boil. Reduce heat setting after water boils.
Medium High—(Setting halfway between HI and
MED) Maintains a fast boil on large amounts of food.
MED—Sauté and brown; keeps food at a medium boil.
Medium Low—(Setting halfway between MED and
LO) Cook after starting at HI; cooks with little water
in covered pan.
LO—Used for long slow cooking (simmering) to
tenderize and develop flavors. Use this setting to melt
butter and chocolate or to keep foods warm.
NOTE: The surface unit “on” indicator light may
glow between LO and OFF, but there is no power
to the surface units.
Appearance may vary slightly.
Special Notes for Glass Cooktops:
(on some models)
Cooktop temperatures increase with the number of
surface units that are on. With 3 or 4 units turned
on, surface temperatures are high so be careful
when touching the cooktop. The hot surface
indicator light will remain lit after the surface unit
is off until the surface is cool enough to touch.
NOTE:
• At HI and Medium High settings never leave food
unattended. Boilovers cause smoking and greasy
spillovers may catch fire.
• At Medium Low and LO settings melt chocolate
and butter on a small surface unit.
• When a surface unit is turned on, the unit can be
seen glowing red within a few seconds. The red
glow will turn on and off (cycling) to maintain the
selected heat setting. With poor cookware, you will
see frequent cycling of the unit off and on. Good,
flat cookware will minimize the cycling. See the
Glass Cooktops section of Surface Cookware Tips.
• It is safe to place hot cookware from the oven or
surface on the glass surface when it is cool.
(continued next page)
11
Home Canning T
ips
Surface Contr
ols
Medium Low
Medium High
Summary of Contents for JBS03
Page 37: ...37 NOTES The Problem Solver ...
Page 38: ...38 NOTES ...
