49-50323
7
Installation
Instructions
Faucet Mount Filtration System
GXSV65R
INST
ALLA
TION INSTRUCTIONS
IMPORTANT INSTALLATION
RECOMMENDATIONS
WARNING
Read entire manual. Failure to
follow all guides and rules could cause personal
injury or property damage.
Ŷ
Check with your local public works department
for plumbing codes. You must follow their guides
as you install the Water Filtration system.
TOOLS AND MATERIALS
REQUIRED FOR INSTALLATION
Ŷ
Phillips screwdriver
Ŷ
Two (2) adjustable wrenches
Ŷ
(OHFWULFGULOODQGGULOOELWWRGULOOƎKROHW\SH
as required) if mounting hole is needed for
faucet
Ŷ
Tape measure
Ŷ
If your main water line is a rigid pipe, you will
require a compression fitting and possibly
other plumbing hardware to complete the
installation.
CAUTION
To avoid damaging the sink
or countertop, consult a qualified plumber or
installer for drilling procedures. Special drill bits
may be needed for stone, porcelain or stainless
steel.
CONTENTS INCLUDED WITH THE
PRODUCT
Ŷ
Water filter system assembly, including mounting
screws
Ŷ
Feed water adapter
Ŷ
Faucet assembly with electronic base monitor
and tubing
COLD WATER SUPPLY FITTING
A. PREFERRED INSTALLATION
(Utilizing existing kitchen sink water supply valve
and flexible faucet tubing)
A typical connection using the included water supply
fitting is shown in the illustration below.
1. Close the water shut-off valve that is immediately
in front of the supply tube and open the faucets to
drain water from the sink cold water pipe.
2. Remove the nut that connects the cold water faucet
to the supply tube. Some water may spill out.
NOTES:
Ŷ
Be sure to turn off the water supply and open
a faucet to drain the pipe.
Ŷ
Make sure the gasket is installed in the water
supply fitting.
+DQGWLJKWHQWKHZDWHUVXSSO\ILWWLQJRQWRWKHFROG
water faucet. Be sure the gasket, as shown, is
in place before final assembly. Finish tightening
with an adjustable wrench.
Be careful not to
overtighten or cross-thread, as damage to the
threads can occur.
0DNHVXUHWKHƎTXLFN
connection is not against a wall that causes the
supply tubing connection to bend. A quarter
turn to tighten or loosen the adapter may be
necessary to avoid this.
4. Reconnect faucet tubing line to the fitting.
5. Install tubing. (See Installing the Tubing section.)
Cold Water
Faucet
Stud
Cold
Water Pipe
Water Supply
Fitting
Ǝ7XELQJWR
Water Filter Inlet
Cold Water Shutoff
Gasket
Fig. 1
