Installation Instructions
19
REVERSING THE DOOR
B
REVERSING THE DOOR - GLASS PANEL
DOOR MODELS
1
Open the door approximately 130 degrees. With a
putty knife, remove the 4 plastic caps located along
the left side of the front panel and set them aside.
2
Remove the bottom screw from each hinge (right
side) and partially insert them into each top hinge
hole on the left side.
NOTE: All 4 front panel hinge screws will now be in
the top hinge holes - 2 on the left and 2 on the right.
3
Loosen each top hinge screw on right side. Remove
the door and place it on a protective flat surface to
avoid any damage.
Plastic Cap (4)
Left side of
front panel
Loosen each top
hinge screw on
right side
B
REVERSING THE DOOR - GLASS PANEL
DOOR MODELS (cont.)
4
Remove both the blind plate and the strike plate and
install them in the opposite positions.
5
Remove the 4 door hinge screws, 6 inside screws and
2 pocket screws. Lift the inner door upwards using a
flat blade screwdriver.
Blind
plate
Strike
plate
Inner door
Outer door
Inside
screws
Inside
screws
Pocket screws
Inside
screw
Door
hinge
screws
