6
49-3000198-1
A
B
C
Power
Press to “wake up” the display. If the display is active, press to put the dryer into idle mode.
NOTE:
Pressing
Power
does not disconnect the appliance from the power supply.
Start and Pause
Press
Start
to begin the cycle.
NOTE:
The door must be closed for the dryer to start the cycle. Pressing
Start
again will pause the cycle, the
Start
light will blink and “
Pause
” will display.
To continue the cycle, press
Start
again.
Display and Status Lights
The display shows the approximate time remaining until the end of the cycle.
In addition, this display will show the dryer status:
Features and appearance will vary.
Getting started
USING THE DR
YER
A
C
E
B
F
D
H
I
G
H
Controls
Drying
Cooling
Pause
Damp
Sensing
Cycle Status:
On
Damp
Less Dry
Dry
Lint Filter
Clean
More Dry
No Heat
Low
Medium
Check Vent
High
Est. Time
Remaining
20 min.
40 min.
60 min.
90 min.
10 min.
20 min.
A
C
E
B
D F
G
H
E
H
I
Pause
(on some models)
The
Start/Pause
light will flash and the message “
Pause
” will show in the display when
the dryer’s cycle is paused. The cycle may be re-started by pressing the
Start
button.
WiFi
(on some models)
Will allow your appliance to communicate with your smartphone for remote appliance
monitoring control and notifications.
Controls
The dryer is locked - will blink once if you press any button or turn the cycle knob.
Sensing
Indicates the dryer is sensing the level of dampness to determine estimated cycle time
remaining.
Clean Lint Filter
The
Clean Lint Filter
light will stay on for 15 seconds after the cycle stops.
Check Vent
(on some models)
The
Check Vent
light indicates an issue has been found due to reduced airflow from a possible
blocked or restricted vent. Checking and/or cleaning the vent system is recommended. See the,
“Check Vent” light is on
in the
Troubleshooting Tips
section.
