GE GE Profile JDS28DNWW, Installation Instructions Manual

Page: 8 / 24

8
Installation­Instructions
INSTALL STOP SCREW
These­screws­prevent­the­range­from­sliding­out­of­
position­during­operation.­
1.­­­Carefully­mark­the­cabinet­for­the­location­of­the­
stop­screws.
2.­­­Drill­1/8”­pilot­holes­into­cabinet,­on­each­side­of­
the­range.­(Do­not­drill­entirely­through­the­cabinet­
wall.)
3.­­­Carefully­turn­the­shoulder­screws­into­the­pilot­
holes­until­they­are­tight.­
PLACING RANGE INTO THE OPENING
1.­­­It­is­recommended­that­two­people­lift­the­range­
into­place,­carefully­setting­the­side­metal­flanges­
under­the­glass­on­the­edges­of­the­countertop­
opening.­
2.­­­Carefully­slide­the­range­toward­the­back­of­the­
opening.­­Stop­pushing­the­range­when­there­is­till­
a­4”­gap­at­the­front­before­flushing­the­range­with­
the­counter.­
REMOVE THE PROTECTIVE CHANNELS (if provided)
Carefully­remove­the­protective­channels­from­the­
sides­of­the­glass­cooktop.­This­may­require­a­slight­
lifting­of­the­range­to­remove­the­weight­of­the­range­
from­the­protective­channels.
CHECK ANTI-TIP BRACKET
With­the­range­still­sitting­out­from­the­counter-top,­
confirm­the­anti-tip­bracket­is­securely­attached­to­
the­rear­of­the­range,­and­slide­the­range­back­so­that­
the­anti-tip­bracket­slides­just­under­the­countertop­or­
wood­block­attached­to­the­rear­wall.­
If­the­range­is­pulled­from­the­wall­for­any­reason,­
always­repeat­this­procedure­to­verify­the­range­is­
properly­secured­by­the­anti-tip­bracket.
7
­
INSTALL THE RANGE
Gap­Approx.­4”
Gap­Approx.­4”
Glass­Cooktop
Protective­Cover
Remove Protective Cover from Both Sides after Range is in Cabinet
Countertop
Oven
Anti-Tip Bracket
Countertop or
Wood Block