GE GE Profile JDS28DNWW, Installation Instructions Manual

Page: 9 / 24

9
Installation­Instructions
LOCATING THE STOP SCREW
Carefully­slide­the­range­towards­the­back­of­the­
opening.­When­the­range­is­approximately­1”­from­
the­back­of­the­opening,­lift­the­front­of­the­range­
approximately­½”­to­clear­the­stop­screw­located­
in­the­sides­of­the­cabinet.­­Slide­the­range­until­it­is­
seated­into­the­opening.­
Lower­the­front­of­the­range­onto­the­counter-top.­
ATTACH THE LOWER TRIM
Attach­the­lower­trim­(supplied­separately­with­the­
range)­to­the­bottom­of­the­vertical­side­trim­with­the­
4­screws­supplied.­
7
­
INSTALL THE RANGE (Continued)
Side­
trim
Lower­
Trim
Lower­
right­
end­of­
front­
frame
Remove Oven Door
1.­­­Lift­the­oven­door­by­placing­one­
hand­on­each­side.­the­door­is­
heavy,­so­you­may­need­help.­Do­
not­lift­the­door­by­the­handle.
2.­­­With­the­door­at­the­same­
angle­as­the­removal­
position­(halfway­between­
the­closed­and­broil­stop­
position)­seat­the­notch­
of­the­hinge­arm­into­the­
bottom­edge­of­the­hinge­
slot.­The­notch­of­the­hinge­
arm­must­be­fully­seated­
into­the­bottom­of­the­seat.
8 ­
REPLACING THE OVEN DOOR
Hinge Arm
Bottom­
Edge­of­
Slot
Hinge­Notch
Attach­2­
screws­
each­
side
Clear
Lower­
Trim
Shoulder­
Screw
Notch­in­Bottom­
of­Side­Trim
Look­at­both­sides­of­the­range­under­the­door.­The­
stop­screws­must­be­located­in­the­notch­on­the­
sides­of­the­range,­and­not­touch­the­top­of­the­notch­
when­the­range­is­fully­seated­on­the­countertop.­If­
the­screws­do­not­meet­the­requirements,­move­the­
screws­to­a­position­that­meets­these­requirements.­
(See­illustration.)
CHECK FOR PROPER INSTALLATION OF THE STOP SCREW