Chapter 5: Web-Based Management
GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
113
IGMP version 2 introduces some enhancements such as a method to elect a
multicast queried for each LAN, an explicit leave message, and query messages that
are specific to a given group.
The states a computer will go through to join or to leave a multicast group are shown
below:
Figure 5-57: IGMP State Transitions
•
IGMP Querier
A router, or multicast-enabled switch, can periodically ask their hosts if they want to
receive multicast traffic. If there is more than one router/switch on the LAN
performing IP multicasting, one of these devices is elected "querier" and assumes the
role of querying the LAN for group members. It then propagates the service requests
on to any upstream multicast switch/router to ensure that it will continue to receive
the multicast service.
NOTE:
Multicast routers use this information, along with a multicast routing protocol
such as DVMRP or PIM, to support IP multicasting across the Internet.
IGMP Configuration
The Industrial Switch support IP multicast, you can enable IGMP protocol on web
management's switch setting advanced page, then the IGMP snooping information
displays. IP multicast addresses range are from 224.0.0.0 through 239.255.255.255.
Summary of Contents for GE-DSH-73
