– 14 –
Troubleshooting Electronic Control Cooktop Elements
To check an element from the relay board, follow this example for the center element.
1. Disconnect power to the cooktop.
2. Carefully remove the cooktop from the installation and lay the glass side down on a protected surface.
3.
5HPRYH¿YHLQKH[KHDGVFUHZVIURPWKHUHOD\ERDUGFRYHU
4. Check the resistance from J501 pin 1 grey/black to J501 pin 3 grey. It should measure approximately 76
ohms.
5. To check the thermal limit switch from the relay board; check the resistance from J501 pin 1 grey/black
to grey wire on K516 terminal. It should measure approximately 32 ohms.
Location of the test points on the relay board.
