Read these instructions completely and carefully.
Installation of the range.
BEFORE YOU BEGIN
Installation of this range must conform with local codes, or in the absence of local codes,
with the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest edition. In Canada, installation
must conform with the current Natural Gas Installation Code, AN/CGA-B149.1 or the current
Propane Installation Code, CAN/CGA-B149.2, and with local codes where applicable. This range
has been design-certified by CSA International according to ANSI Z21.1, latest edition and
Canadian Gas Association according to CAN/CGA-1.1 latest edition.
As with any appliance using gas and generating
heat, there are certain safety precautions you
should follow. You will find these precautions in
the
Important Safety Information
section in the
front of this manual. Read them carefully.
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES.
NOTE:
This appliance must be properly grounded.
IMPORTANT:
Save these instructions for the local
electrical inspector’s use.
NOTE TO INSTALLER:
Leave these instructions
with the appliance after installation is completed.
NOTE TO CONSUMER:
Keep this Owner’s Manual
and Installation Instructions for future use.
SERVICER:
The electrical diagram is in an envelope
attached to the back of the range.
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.
If you smell gas:
Open windows.
Don’t touch electrical switches.
Extinguish any open flame.
Immediately call your gas supplier.
CAUTION:
FOR PERSONAL SAFETY,
DO NOT USE AN EXTENSION CORD WITH THIS
APPLIANCE. REMOVE HOUSE FUSE OR OPEN
CIRCUIT BREAKER BEFORE BEGINNING
INSTALLATION.
This appliance must be supplied with the proper
voltage and frequency, and connected to an
individual, properly grounded circuit, protected
by a circuit breaker or time-delay fuse, as noted
on the rating plate.
Wiring must conform to National Electric Codes.
If the electric service provided does not meet the
above specifications, have a licensed electrician
install an approved outlet.
Because range terminals are not accessible after
range is in position, flexible service conduit or cord
must be used.
ELECTRICAL REQUIREMENTS
■
This product must be installed by a licensed
plumber or gas fitter.
■
When using ball type gas shut-off valves, they
shall be the T-handle type.
■
A flexible gas connector, when used, must not
exceed 3 feet.
IN THE COMMONWEALTH OF MASSACHUSETTS
Consumer
S
uppor
t
Operating
Instructions
Safety
Instructions
Installation
Instructions
Tr
oubleshooting
Tips
39