GE AquaTrans AT600, User Manual

Page: 98 / 216

Chapter 4. Initial Setup and Programming
86 AquaTrans™ AT600 User’s Manual
4.7.10 Calculating the Path when Clamp-on selected
Select
Path
and press [√]. The following screen opens.
Press
[

]
again. Record this calculated transducer spacing for use in
installing your transducers on the pipe. The calculation is based on your
Sensor Setup
input (pipe, transducer, fluid, and transducers).
Note:
If setting the calculated spacing for your transducers is not
possible, contact the factory for assistance. Only if instructed by
the factory, press [

] again, and a screen similar to the following
opens.
Use the [

] or [

] key to select a specific digit, then use the [

] or [

] key
to change that digit as required. After all digits are correct, press
[

] t
o
save. Then, press [

] to return to the previous screen.
IMPORTANT:
Changing the transducer spacing should only be completed
according to instructions received from the factory.
Sensor Setup
Traverses
Fluid Type
Fluid Temperature
Path
Path
Transducer Spacing
0.000 mm
Transducer Spacing
UNIT: mm
0.000
]MOVE
]UNDO [ ]SAVE
]
]
]MODF [