GE Appliances DVM1950, Technical Service Manual

Page: 22 / 48

– 22 –
Interior Light
The interior light is 120 VAC, 50 watt halogen bulb
(Part # WB25X10026.)
To remove the interior light:
2. Using a Phillips-head screwdriver, remove the
screw securing the interior light cover.
1. Remove the grille assembly. (See
Grille Assembly
.)
3. Raise the bulb receptacle/bracket assembly.
Note: Do not touch the surface of a quartz halogen
bulb with bare fi ngers because the quartz surface
will be exposed to the salts and oils on the skin. This
will cause heat to concentrate in this area and lead
to premature lamp failure. If you happen to contact
the bulb with your
fi ngers, carefully clean the quartz
surface with a gentle solvent, such as alcohol.
To disassemble the door:
1. Place the door, face down, on a protective
surface.
2. Using a putty knife, carefully pry the choke
cover away from the door frame.
3. Remove the Phillips-head screw from the
bottom left corner that fastens the bottom of
the oven door handle.
4. Using a fl at blade screwdriver, disengage the 9
door frame retainers (3 each on top and bottom,
2 on hinge pin side, and 1 on latch side), then
separate the door frame from the door panel.
5. Using long nose pliers, remove the latch spring,
then slide and remove the latch from the choke.
Latch Spring
Latch
Retainers (1 of 9)
( Continued next page )
Bulb Receptacle/Bracket Assembly