To
Chassis into Cabinet or Wall Sleeve...
1.
Slide the chassis into the
installed cabinet (provided with
models) or wall sleeve
or
(not provided)
designed for
and
models. Make sure that the tubing
on the unit is not touching the wall
case and that the wall case
insulation is secure.
2. Turn the chassis locking plate
90° upward and lock the chassis
with the plate.
Chassis
Models
3.
Secure the line cord to the base
pan with the clamp provided.
Ground Wire on
models,
disconnected when the chassis was
removed from the cabinet, must be
reconnected to the cabinet as
shown in step 3 under Prepare the
Chassis on page 11.
WHEN THE LINE CORD RUN
IS TO THE LEFT SIDE OF
THE UNIT,
extend enough cord to
reach the wall receptacle. (Excess
cord length may be stored in the
space just below the electrical
component box). Insert the line
cord under the clamp provided with
the unit.
4. Mount the
on the front of
the chassis
the top of
the grille onto the top of the chassis
and pushing bottom of grille in
until it snaps into place.
This step must be followed before
reinstalling the chassis locking
Summary of Contents for AJ806L
Page 14: ...Notes 14 ...
