❑
iNSTALLCA61NET
WINDOW.
1. Remove paper backing from seal strip and
affix seal strip to bottom of top channel.
Fasten top channel to top of cabinet with four
long screws.
1/2”
2.
Remove screw fastening upper guide of slider
assembly to window sash. DO NOT RAISE
WINDOW.
3. Insert cabinet (with chassis still removed) into
opening of slider assembly and over bottom track.
Permit cabinet top channel to rest against upper
guide of slider assembly.
Push lower corners of
toward outdoors
until cabinet bottom slides up and over the bend in
bottom track.
Top
channel
Sash
Upper guide
Cabinet
Bottom track
fits into cabinet
track
Insert
screw
1
Bottom
track
Drill 1/8” hole in sill by drilling down through
center hole in cabinet. Fasten cabinet to sill with
1/2” screw.
5. Cut the foam sash-gap gasket to the correct
window width and “stuff” it between the top of
the lower sash and the glass pane of the upper
sash to provide a seal.
❑
ATTACH WINDOW FILLER
Window filler panel assemblies are built
U-shaped slider assemblies.
1. Expand both filler panel assemblies toward
sides of
2. Fasten side flanges of filler panel assemblies to
sides of
using 1/2” long screws provided.
Be sure to utilize all 3 screw openings in each
flange to prevent air seepage through improperly
sealed flange areas.
❑
lNSIAllcMASSIS
1. Slide chassis carefully into cabinet as far as it
will go.
2. Lock security lock to prevent chassis from
being pushed from the outside into the room to
gain illegal entry. Slide security lock screw to the
right. Tighten screw.
4. Lineup top channel and upper guide center
holes. Replace screw removed earlier from sash.
I
When cabinet installed will be properly
pitched to outdoors for condensate removal.
11