GE ACV24D, Use And Care & Installation Manual

Page: 10 / 16

WINDOW INSTALLATION
WINDOW
FILLER PANELS.
1. Measure center of window opening. Mark
center position on both the window sill and the
window sash.
2.
Raise the window sash.
3. Position bottom track over sill.
Using track as a template, position center hole of
track over center mark made on window sill.
Mark
of all track holes on window sill.
Drill three 1/8” diameter holes in window sill.
Attach track to window
with three 1/2”
screws provided.
4.
Fit left and right U-shaped sliders into upper
guide. Be sure drain holes at bottom of sliders are
at the rear (facing out of doors).
Slider mounting holes
on frame behind
window filler panels
Upper
Top
channel
I
guide
1
. . .
Drain holes in rear
\
Bottom track
5. Fit lower halves of U-shaped sliders into bottom
track. Pivot assembly forward toward sash.
‘Sash
‘Upper
guide
INDOOR SIDE
Bottom
track
6.
Holding upper guide at approximate sash
center, slide left and right-hand sliders into window
sash tracks.
7.
Lower window sash behind upper guide.
Center upper guide at sash centerline. Be sure
sash is lowered flush to upper guide.
Drill 1/8” diameter hole in sash to meet center
hole in upper guide.
Install 1/2” long screw through upper guide hole
into sash center hole just drilled.
Do not
completely tighten screw yet.
8. Drill four 1/8” diameter holes in sash tracks
using sliders as templates. Pull window filler panel
slightly forward if necessary to locate screw holes.
Secure sliders in sash tracks with four
diameter screws.
Pull window filler
to
10