LED Refigerated Display Lights – Cleaning Instructions
• The outer lens and the plastic housing should be cleaned
periodically with a mild liquid dish detergent.
• Do not use chemical cleaners to clean the lens.
• Keep the outside clean. Wipe with a clean cloth lightly
dampened with mild liquid dish detergent. Dry with a clean,
soft cloth.
• Do not wipe the lens with a soiled dish cloth or wet towel.
These may leave a residue that can damage the finish.
• Do not use scouring pads, powdered cleaners, bleach or
cleaners containing bleach because these products can
scratch and damage the finish.
11776-R110813
9
Risk of electrical shock.
Plastic cover is needed to protect electrical wires from tampering and accidental contact. /
Risque de choc électrique.
Le couvercle en plastique est requis pour assurer une protection adéquate contre l'accès aux fils et les contacts accidentels.
CAUTION / ATTENTION
7
Risk of electrical shock.
Disconnect power to LED Lights before any cleaning operation.
Risque de choc électrique.
Débranchez l'alimentation des éclairages à LED avant toute opération de nettoyage.
WARNING / AVERTISSMENT
Attach Covers to End Cap
• Tuck wires underneath Wire Cover before installing it onto
the End Cap.
• Attach Wire Cover to LED Light End Cap by inserting a
M2.9x10 pan head tapping screw (provided) through the
holes in Covers and Mounting Tabs using an installation
torque 0.32 N-m (3 lbf-in)
NOTE:
Tighten slowly until fully seated, do not over tighten
or strip the threads.
Wire
Cover
End Cap
M2.9x10 pan
head tapping
screw
8
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelighting.com
1 - 8 8 8 - 6 9 - 4 3 - 5 3 3
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. Immersion is a trademark of GE Lighting Solutions, LLC. The GE brand and logo are trademarks of the General Electric Company.
© 2013 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
This product is intended solely for the use of commercial refrigerated, display or case lighting and is not intended for use in
any other application.
