Risk of electrical shock.
Only those open holes indicated in the photographs and/or drawings may be made or altered as a result of kit installation. Do not leave
any other open holes in an enclosure of wiring or electric components
/ Risque de choc électrique.
Seuls les trous ouverts indiqués dans les photos et / ou les
dessins peuvent être faites ou modifiés à la suite du montage du kit. Ne pas laisser autres trous ouverts dans l'enceinte du câblage électrique ou composants.
WARNING / AVERTISSMENT
3
• Measure the total width of the mullion, and mark a vertical
line half the total width near the top and bottom of the mullion.
• Prepare for the upper end of the Center LED Light. Mark a
horizontal line a minimum 54 mm (2 1/8-inches) from the top
of the mullion, and another horizontal line 10 mm (3/8-inches)
below this line.
• Prepare for the lower end of the Center LED Light. For
750 mm (30-inch) LED Lights, mark a horizontal line 687 mm
(27 1/32-inches) beneath the first line drawn for the top
Mounting Tab. For 900 mm (36-inch) LED Lights, mark a
horizontal line 836 mm (32 29/32-inches) beneath the first
line drawn for the top Mounting Tab.
• Point the center punch directly at the intersection of the
horizontal lines and the vertical line (top and bottom) and
establish a dimple.
• Use power drill and 2.8 mm (7/64-inches) drill bit to drill
holes at the intersection of the vertical center line and the
horizontal lines.
Prepare for Installation of
Center LED Lights
2
of mullion
Total width
10 mm (3/8")
For 750 mm (30-inch)
LED Lights:
687 mm (27 1/32")
Center punch
at intersection
and drill a
2.8 mm (7/64")
hole
mullion
Half total
width of
LED Driver wires -
top
For 900 mm (36-inch)
LED Lights:
836 mm (32 29/32")
Install Center LED Lights
3
LED Driver
Leads
Center LED Light
Power Leads
Mounting Tab
• Place the Center LED Light against the face of the mullion
near the two holes drilled at the top.
• Insert a M3.5 x 1.3 x 13 (#6-32 x ½-inch) sheet metal screw
into the top slot of the Mounting Tab on the Center LED Light
and into the first hole that was drilled in the center mullion.
• Use a screwdriver to start threading the screw into the
drilled hole.
• Refer to the manufacturing manual for door frame to ensure
there are no components contained inside the mullion that
could be drilled through. Use a M3.5 x 1.3 x 13 (#6 - 3/4-inch)
self-drilling screw to attach the Center LED Light into one
or two of the additional drill through holes located near the
center of the LED Light.
• Repeat for the second screw, and for the lower end of the
Center LED Light.
• Refer to wiring diagram on page 5. Connect the red and black
output wires from the LED Light to the red and black wires on the
LED Driver using the twist lock splice wire connectors provided.