Pg 5
gMax Initial Run (Required)
LCD Screen Breakdown
1. You
must run the supplied gcode
fi
le
to test your gMax printer
a er transport. Slide the SD card (
upside-down
) into the le side
of the LCD screen.
2. On the LCD screen, the no
fi
ca on area will say “
Card Inserted
”.
If not, try removing the SD card and reinser ng it and make sure
the “
lock
” is in the o
ff
posi on on the side of the card.
3. Select “
Print > TFT SD > gMax Ini
Ɵ
al Setup
”.
The test
fi
le will perform several func ons:
• X, Y, Z Axis Motor test (slow and fast)
• Mul ple Homing Test
• Extrusion test (with heat)
• Fan test then cooldown
Heated
Bed Temp
Hotend #1
Temp
No
fi
ca ons
Se ngs
Menu
Fan
Speed
Printer
Speed
Coordinates of
Extruder (X, Y, Z)
Current Temp /
Target Temp
Menu
No
fi
ca ons
“
P i
The gMax “Initial Run Test File”
should take about
15 minutes
to complete. If the printer fails
during any of these tests or the
bed probe doesn’t drop/raise
contact support.
Note
”.
