Jaguar V User Manua
l
Operation
4-8
4.5
How to Cut 3mm Letters
To obtain good quality output, narrow media is recommended. However, if wide media is used,
you should:
1. Position two pinch rollers as close as possible to both edges of the cutting area.
2. Make sure the loaded media is held flat with equal tension across the platen.
3. Suggested operation settings:
Tool force: 55 gf. (or depending on the material)
Cutting speed: 45-50 cm/sec
Tool up speed: 45-60 cm/sec
Smooth cut: Disable
Quality: Small Letter
4.6
How to Make A Long Plot
When you are making a long plot, you need to use the
“AUTO UNROLL MEDIA“ function and
turn off the power of Take-up System. The following parameter settings are to help users get the
best cutting quality. The actual output quality may vary when using different kind of materials
1. If the length of graphic is between 3m and 5m, the cutting speed is better slower than
72cm/sec and the cutting quality is set as Normal.
2. If the length is longer than 5m or if the material type is difficult to cut, it is better to further
slow down the cutting speed.
3. After loading the roll media all pinch rollers are raised at this stage, flatten the media on the
platen and hold the front edge of the roll media firmly. Then turn the roll downward to
make an equal tension across the media.
4. Engage pinch rollers.
5. The protrusion length of the blade should be longer than the thickness of the vinyl.
(Please check
the “Blade Specification: About the Tool” in Appendix.) After you notice all
the above,
you’ll enjoy your gigantic signs production!