GCC Technologies J5 Series, Maintenance Manual

Page: 49 / 59

Version : 9.0
49
5.1.6 Diagnostic Test for Motor Encoder and Tool Holder Encoder
This feature provides the ability to diagnose the X and Y motor encoder and tool holder encoder. If the encoder is defective,
the cutting plotter cannot work properly. To check if the encoder is bad or good, you can apply a slight force to the tested part
(such as a drum, the tool carriage or the tool holder) then examine the readings. If the encoder reading changes dramatically,
the encoder is bad. Refer to the maintenance chapter to replace the motor or tool carriage.
X Motor Encoder ?
U p /D o w n K e y
E n ter K ey
C a n c el_ k ey
Move Drum by Hand.
Wait for 3 seconds.
P r e v i o u s /N e x t test item
D is p lay e n c od er c o u n t
X Motor Encoder Reading
Cancel
X Motor Encoder Test
Y Motor Encoder ?
Up/Down Key
Enter Key
Cancel_key
Move Carriage By Hand
W ait for 3 seconds
Previous/Next test item
Display encoder count
Y Motor Encoder
Reading CANCEL