Operation, hot lamination
1
Operation, cold lamination
Connect power cord to appropriate power source.
Push power button to “ON” position. The green power indicator will
illuminate.
Turn temperature knob to the cold setting.
Follow the instructions include with your GBC Self Adhesive
laminate or other pressure-sensitive, non-thermal laminating
pouches.
1
Specifications
Electrical
Machine Dimensions
Machine Weight
Maximum Pouch Width
Minimum/Maximum
Pouch Thickness
Maximum Thru-put Thickness
Warm-Up Time
GBC HeatSeal H400
230V/50Hz/3.1A/700W
500 x 190 x 114mm
3.9kg
324mm
2x75 mic. (TOTAL 150)
2x250 mic. (TOTAL 500)
1.3mm
3-5 min./2x75 mic. (TOTAL 150)
Connect power cord to appropriate power source.
Push power button to "ON" position. The green power indicator will
illuminate.
Using the included lamination guide, select appropriate
temperature setting for the pouch gauge thickness and material
you are laminating.
Temperature Setting Guidelines*
When laminating thin paper with light ink coverage, set the
temperature dial at the low end of the range. Thick paper and
heavy ink coverage require higher settings within the range.
Temperature setting will vary due to the finish, chemistry and heat
absorption properties of the material being laminated. If pouch is
cloudy the first pass through the machine, adjust temperature
higher and run through again. If waviness occurs, reduce the
temperature. Always allow sufficient time for laminator to adjust
to changes in temperature setting.
The inside of the laminator will glow red when the laminator has
reached operating temperature.
Position the item to be laminated into a GBC laminating pouch, so
that the document is aligned to the folded edge and right and left
borders are equal.
Insert the pouch and its contents straight into the machine, leading
with the sealed edge (fig. 1).
The laminated document will automatically exit the rear of the
laminator. After the pouch has stopped moving, place it on a flat
surface to cool before handling.
When you are finished laminating, push the power switch to “OFF”.
Do not laminate an empty pouch.
2
2
3
Anti-jam feature
How to use the Release Lever (fig. 2)
Turn off the laminator immediately
Press the release lever down to release the motor from the rollers
Pull your document back out of the laminator
Clean the rollers by running the cleaning sheet supplied with the
laminator through the machine 2 or 3 times in hot operation mode.
If you do not have this sheet just use or a similar cardboard sheet
that fits the width of the laminator
1
3
2
4
3
4
5
6
7
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 96333500
