GBC AutoUltima Pro, Instruction Manual

Page: 12 / 150

12
AutoUltima Pro – Troubleshooting
Symptoms Possible cause Corrective action
No power switch, does not illuminate when
in on position Power cord is not plugged
into live power outlet Plug into live outlet
Circuit breaker has tripped Reset circuit breaker at
rear of machine
Machine does not respond after pressing
standby button Cover is open Close cover
No paper in feeder Insert paper
Idler bar assembly
not latched Latch idler bar levers
Document collection tray
is not fully inserted Fully insert document
into exit tray
Main power switched off Turn on power
Low film Load new film
Faint lines across the document
Cloudy lamination
Wavy lamination
Unsatisfactory adhesion to media
Machine is not fully warm Allow time to warm up
Incorrect film setting Select correct film setting
Insufficient heat Verify correct film setting
Media not compatible Media is not suitable
for thermal lamination
Feeder does not feed document Media not compatible
with feeder Manually feed single
sheets
Paper is not fully inserted
to feeder Fully insert paper to
feeder
Document is skewed in film Feeder side guides
not set correctly Adjust feeder side guides
to paper size
Feeder picks multiple documents Static electricity on media, or
media is stuck together Fan paper and replace
in feeder
Wrinkles in document EZ Load levers not closed Close EZ Load Levers