GBC 620OS, Installation And Operating Manual

Page: 14 / 23

GBC 620os Operation Manual
© 2007 General Binding Corporation Page 14
LOADING FILM & THREADING FILM
Locking Pins
Figure 1
“O”-Rings
Film Shaft Support Bracket
Film Shaft
Figure 2
Top Idler
Lower Idler
Main Roller
Figure 3
Figure 4
DO NOT USE COLORED PRINTS AS SHOWN IN
PHOTOS FOR THREADING.
STEP 1:
•
Preheat the laminator to desired temperature.
•
Turn on the Air Compressor.
STEP 2:
•
Pull the Locking Pins out of the Film Shaft
Support Bracket . ( Figure 1 ).
•
Swing the Film Shaft Support Bracket out and
slide the roll of film onto the Film Shaft , over the
Core Adaptors . ( Figure 2 ).
•
Slide the “O”-Ring over the end of the Core
Adaptors to keep the roll of film from shifting
from side to side. ( Figure 2 ).
STEP 3:
•
Guide the film over the Top Idler Bar .
( Figure 3 ).
•
Continue by webbing the film under the Lower
Idler Bar. ( Figure 3 ).
•
Drape the film over the Main Heat Roller .
( Figure 3 ).
•
Lower the Idler assembly to the lower position
and lock in place.
STEP 4:
•
Insert a “ Threading Card ” into the nip by
pressing and holding “ LOADING ”. The
“ Threading Card” should be long enough to
reach the Pull Rollers into the nip area. NOTE:
Use unprinted material to perform this
function. If Printed paper must be used, make
sure the printed area of the sheet DOES NOT
make contact with the Heat Roller.
Continue to
feed the Threading Card until the trailing edge
clears the Feed Gate and about 3 inches of the
image is left exposed.
( Figure 4 ).
•
Remove the Front Safety Shield. NOTE: The
Top Main Heat Roller is HOT. Use extreme
caution not to touch the Heat Roller.
•
Set Motor Speed to lowest speed or speed 1.