GBC 4064WF-1
Operation Manual
© 2009 GBC an ACCO Brands Co.
Page 20
FIGURE 25
FIGURE 26
Start Laminating
1.
At this point you should have your laminator
webbed with the appropriate material for your
application.
2.
The feed table should be in the normal operating
position.
3.
Close the main and Pull roll nips. Rollers should
be closed.
4.
Speed is set to 3 or less and front () motor
direction is selected.
5.
Press the start ( ) button.
6.
Set main roller pressure between 40% – 60% for
laminating by turning the main roll lift handle.
CAUTION: If using PSA film, an air pocket may
form between the main rollers and pull rollers.
Raise the pull rollers to allow the air Pocket to
pass.
7.
Make any necessary film brake tension
adjustments, pull/main roller pressure, and
clutch and/ or rewind brake tension adjustments.
8.
Position the item to be laminated on the feed
table.
9.
Align the leading edge of the item parallel to the
heat roller nip (Fig. 25).
10.
Use both hands to force the image outward and
slowly push inwardtoward the nip of the heat
rollers (Fig. 26).
CAUTION: Avoid forcing the image into the
main roller nip as this action will cause the
corners of the leading edge to buckle and create a
wave.
Summary of Contents for 4064WF-1
