GBC 4064WF-1
Operation Manual
© 2009 GBC an ACCO Brands Co.
Page 22
(1)
.......a PSA film or mount adhesive
(3)
(2)
(2)
PULL WEB
FIGURE 29
FIGURE 30
To unweb the laminator
Unweb the laminator if you are changing film
widths, cleaning the rollers or have finished using
the machine for the day.
CAUTION: Do not cut yourself
1.
Using a slitter, cut (1) the output from the web
(Fig. 29).
2.
Cut (2) remaining top film web between the
idler bar and heat roller. PSA film cut the
release liner too.
3.
Cut (3) the film web between the lower film
supply and the idler bar (Fig. 29).
CAUTION: Be careful not to cut any of the
rollers!
4.
Remove the feed table.
5.
Gap the main rollers and pull rollers.
6.
Carefully grab hold of the web (top and bottom
film), from the front operating position and pull
towards you (Fig. 30).
7.
Do not allow the adhesive side of the film to
contact the heat or pull rollers.
Clearing a Film Jam (Wrap-up)
Film jams (wrap-ups) may occur if the film is loaded
backwards or if the area at which film exits the
equipment is blocked. The film, when jammed,
wraps around the heat rollers or pulls rollers during
webbing.
To clear a jam:
1.
Immediately stop the laminator by pressing
STOP ( ).
2.
Set motor direction to rear.
3.
Use the footswitch to reverse the web until the
wrap up is clear.
4.
Raise the main roller and pull rollers.
5.
Manually guide the web from the main rollers
and pull rollers.
6.
Once the film jam has been cleared, lower the
main roller and pull rollers.
7.
Refer to the section titled START
LAMINATING.
Summary of Contents for 4064WF-1
