7
EN
*Wood Block
When the cut-off wheel has worn down considerably,
use a spacer block of sturdy, non-flammable material
behind the workpiece as shown in the figure. You
can more efficiently utilize the worn wheel by using
the midpoint on the periphery of the wheel to cut the
workpiece.
1
1.Wood Block
MAINTENANCE AND INSPETCTION
CAUTION:
Always be sure that the machine is switched
off and unplugged before attempting to perform
inspection or maintenance.
·Changing Cut-off Wheel
When the cut-off wheel has worn down considerably
and results in reduced efficiency, replace with a new
one immediately.
·Inspecting the Mounting Screws
Regularly inspect all mounting screws and ensure
that they are properly tightened. Should any of the
screws be loose, retighten them immediately. Failure
to do so could result serious hazard.
·After Use
Disconnect the machine after operation and store it
out of reach of children. Brush off accumulation of
dust on the base.
·Lubrication
To prolong the service life of this machine, lubricate
the machine’s active parts every month (refer to the
name of each part).
1.Spinning Part Between Bracket and Clevis Pin with
Head
2.Screw Rod
3.Moving Part of Vise (B)
·Replacing Carbon Brushes
Use a screwdriver to remove the brush holder caps,
take out the worn carbon brushes, insert the new
ones and secure the brush holder caps.
1
2
1.Screwdriver
2.Brush Holder
Cap
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at
the same time.
1
1.Limit Mark
If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his agent
in order to avoid a safety hazard.
Environmental Protection
Waste Disposal
The damaged tools, accessories and waste package
materials should be sorted for eco-friendly recycling
and in accordance with local laws.