5
EN
removing the wheel. Please tighten the hex bolt
securely to avoid severe injury. Be sure to pull
out the stopper pin after installing the wheel or
before switching on the machine.
2
3
4
5
6
7
8
1
1.Drive Spindle
2.Stopper Pin
3.Inner Flange
4.Outer Flange
5.Hex. Bolt
6.Socket Wrench
7.Wheel
8.Washer
*Adjusting the Vise
The maximum angle of the vise is 45°.
To change the cutting angle, first loosen the two bolts
of the vise (A), and then slide vise (A) forward or
backward to desired location, and securely tighten
bolts.
2
3
4
1
1.Bolts
2.Direction A
3.Direction B
4.Vise A
*Spacer Block
When the cut-off wheel has worn down and became
smaller, you can use a spacer block which is slightly
narrower than the workpiece as shown in figure to
utilize the wheel economically.
2
3
4
5
1
1.Diameter of
Workpiece
2.Stationary Vise A
3.Spacer Block
4.Width of Spacer
Block
5.Adjustable Vise
B
*Movement of the stationary vise (A)
When the product leaves the factory, the maximum
opening size of the vise is 156mm.
When you need to increase the size, you can loosen
the two fixing bolts and move the vise (A) along
the opening position on the base. At this time, the
opening size of the vise can be adjusted to 191mm.
Function Descri ption
*Cautions
1. Power Voltage
Before connecting the machine to a power source
(receptacle, outlet, etc.), be sure the voltage supplied
is the same as that specified on the nameplate of the
machine.
2. Protective Earthing Conductor
The machine must be grounded to prevent the
operator from electric shock, and it is equipped with a
standard three-wire and grounding-type receptacle to
adapt to the normal grounding receptacle. The green
and yellow cable is known as the earth wire. Do not
connect it to the live wire.
3. Switch
To avoid accident, always be sure that the tool is
switched OFF before plugging in.
4. Extension Cable
If the extension cable is far away from the power
supply, an outdoor-specific extension cable with
sufficient capacity should be used. A cable with small
capacity will lead to a decrease in voltage, resulting
in damage to the cable.
Always be sure that the extension cable is in good
condition before use.
Be sure to keep the cable away from the working
area and in a proper location, so as not to cut the
cable or be entangled by the wheel during work,
resulting in cable damage or accidents.
*Cutting Operation
1. Hold the handle firmly. Switch on the machine
and wait until the wheel attains full speed before
lowering gently into the cut.
2. When the wheel contacts the workpiece, gradually
bear down on the handle to perform the cut.
3. When the cut is completed, switch off the machine
and wait until the wheel has come to a complete
stop before returning the handle to the fully
elevated position.
4. It’s dangerous for you to remove or install the
cutting material when the wheel is rotating.
*Installing or Removing the Wheel
Mount the inner flange onto the spindle and fit the
wheel on over the inner flange, then fit the outer
flange and the washer onto the spindle in turn. Push
in the stopper pin and secure the hex. bolt with a
socket wrench. Follow the installing procedures in
reverse to removing the wheel.
Caution: Always be sure that the machine is
switched OFF and unplugged before installing or