6
EN
2
1
1.The opening size
of the vise can be
adjusted to 191mm
2.Bolts
*Movement of the adjustable vise (B)
To lock work, push screw rod toward work until the
vise (B) is in contact with the workpiece, lower quick
release lever and turn crank to tighten.
To release work, turn crank to loosen vise (B), lift
quick release lever up, and pull screw shaft away
from work.
2
3
4
1
1.Forward
Direction of Screw
Rod
2.Backward
Direction of Screw
Rod
3.Quick Release
Lever
4.Screw Rod Base
*Lock Chain
Fix the machine for easily moving and storing. Lower
the handle to the position where you can attach the
lock chain to the hook on the handle.
Lower the handle and release the lock chain from the
hook before putting the machine into use.
1
1.Lock Chain
*Spark Guard
A spark guard is equipped for this machine to avoid
many sparks flying around in operation. Loosen the
screw on the bracket and adjust the spark guard to a
position at which minimum sparks will fly around.
1
2
1.Spark Guard
2.Screw
*Cutting Long Workpieces
Long workpiece must be supported by blocks of non-
flammable material on either end so that it will be
level with the base top.
1
1.Blocks
*Cutting at an Angle
When cutting workpiece over 65mm wide at an angle,
attach a straight piece of wood (spacer) over 190mm
long and 45mm wide to the guide plate as shown in
the figure. Attach this spacer with screws through the
holes in the guide plate.
1
2
3
4
5
1.Guide Plate
2.Straight Piece Of
Wood (Spacer)
3. Over 45mm
Wide
4.Over 45mm
Wide
5.Over 190mm
Long
*Switch Action
To start the tool, simply pull the switch button.
Release the button to stop. For continuous operation,
pull the button and then push in the lock button. To
stop the tool from the locked position, pull the button
fully and then release it.
1
2
1.Lock Button
2.Switch Button