Gazelle GC2034, User Manual, Page: 8 / 12

8
EN
custodian must make a routine inspection; Before
use, the user must carry out daily inspection; The
unit using the machine must have full-time personnel
to carry out regular inspection; Check at least once
a year; The inspection period should be shortened
correspondingly in hot and humid areas with frequent
temperature changes or in places with poor working
conditions; It should be checked in time before the
plum rain season.
If the machine passes the regular inspection, the
inspection "qualified" mark should be pasted on the
appropriate part of the machine. The "conformity"
mark should be distinct, clear and correct and at least
include: machine number, name or mark of inspection
unit, name or mark of inspection personnel, date of
validity.
● Maintenance
Always adjust the forward reverse switch to the
center position when servicing the power tool,
replacing the tool on the power tool, or carrying the
power tool.
The maintenance of the machine must be carried
out by a maintenance unit approved by the original
production unit. The user and the maintenance
department shall not modify the original design
parameters of the machine at will, and shall not
use substitute materials that are lower than the
performance of materials and parts and components
that do not conform to the original specifications.
TROUBLESHOOTING
Problem Cause Remedy
The machine does not work, The
battery pack is fully charged and
contact.
Poor contact between battery pack
and the machine.
Reinstall the battery pack.
Machine parts are damaged.
Send the machine back to the
original factory or maintenance
point for repair.
The machine broke down suddenly
while it was working
The battery pack runs out of power
Recharge the battery pack or
replace the fully charged battery
pack
High temperature or overload
protection
Leave the machine and battery
pack to cool
Machine parts are damaged.
Send the machine back to the
original factory or maintenance
point for repair.
The noise of the machine or the
temperature is too high
The gear box is short of lubricating
oil
Add special lubricating oil.
The machine absorbs dust or iron
filings
Clean the machine.
Machine parts are damaged.
Send the machine back to the
original factory or maintenance
point for repair.
The socket comes off easily from
the anvil
The socket is worn. Replace the socket
The spiral retaining ring of the anvil
is worn
Send the machine back to the
original factory or maintenance
point for repair