Gazelle GC2034, User Manual, Page: 5 / 12

5
EN
GENERAL DESCRIPTION
1
2
3
4
5
6
7
1.Anvil
2.Light
3.Switch Trigger
4.Torque Setting Panel
5.Button
6.Battery Pack
7.Reversing
Switch Lever
BEFORE USE
Caution: When installing or removing the battery
pack, please set the reversing switch lever to the
center position to lock the switch so as not to
accidentally touch the switch and cause safety
problems.
● Installing or Removing Battery Pack
1. Installing the battery pack
As shown in the figure below, when inserting the
battery pack, pay attention to insert the battery pack
into the housing correctly. Be sure to insert the battery
pack until you hear the "click" sound, which means
that the battery pack has been firmly installed on the
controller. Otherwise, the battery pack will accidentally
fall off the casing, causing injuries to the operator or
others. Avoid inserting the battery pack with excessive
force or tapping it in with the help of other objects.
* Caution: Only specific battery packs can be used.
The use of battery packs of other brands carries
the risk of injury, personal injury and property
damage due to battery pack explosion.
Fig.A
1
2
3
1.Torque Setting
Panel
2.Button
3.Indicator Light
2. Removing the battery pack
The battery pack is placed under the machine handle,
press the battery pack button down in the direction
of arrow 1, and then pull out the battery pack in the
direction of arrow 2 as shown in the figure.
CAUTION: Don't pull out the battery forcibly!
Fig.B
● Indicator Light
The indicator light on the battery pack shows the
power of the battery pack, indicated by the status of
the four red LED lights.
Fig.C
1.Four LED
Power Indicator
Lights.
The state of Indicator
light
Approx. Battery Power
Left
LED1~LED4 lit >19.6±0.5V
LED1~LED3 lit >19.6±0.5V~18.9±0.5V
LED1~LED2 lit >18.9±0.5V~17.7±0.5V
LED1 lit >17.7±0.5V~16±0.5V
LED1~LED4
extinguished
<16±0.5V
（
*Caution: Please refer to the specific instructions
of the charger.
OPERATION DESCRIPTION
● Switch Action
To start the tool, simply pull switch trigger. Tool speed
is increased by increasing pressure on the switch
trigger and further pressure results in an increase in
speed. Release the switch trigger to switch off the tool.
Caution: Before inserting the battery cartridge
into the tool, always check to see that the switch
trigger actuates properly and returns to the
“OFF” position when released. Do not operate the
machine at a low speed for too long, or the inside
machine may be overheated.