Gazelle GC2034, User Manual, Page: 6 / 12

6
EN
Fig.F
1
2 3
1. Pin
2.Rubber Ring
3.Socket
● Removing the tool
Uncover the Socket Rubber Ring, take out the pin
and pull the socket along the direction of the arrow.
Fig.G
1 2
1. Anvil
2.Socket
Caution: If the pin is found to be worn or broken,
please replace it in time.
Tightening or Removing Bolt/Nut
●
Tightening Bolt/Nut
Place the socket in the bolt head and apply pressure
to the tool. Start the tool slowly and then increase the
speed gradually. Release the switch trigger when the
bolt fixed tightly.
Fig.H
1
2
1. Bolt
2.Socket
CAUTION:
Point the bolt to threaded hole as vertically as
possible.
● Removing Bolt/Nut
Place the socket in the bolt head and start the tool
to its full speed. After bolt was removed completely,
release the switch trigger slowly.
Fig.D
1
1. Switch Trigger
● Reversing Switch Action
Depress the reversing switch lever from side B to
side A for clockwise rotation for drilling and driving in
screws (viewed from the rear of the tool). Depress
the reversing switch lever from side A to side B for
counterclockwise rotation for loosening or unscrewing
screws (viewed from the rear of the tool).
Fig.E
1
2
3
1. Reversing
Switch Lever
2.Counter
clockwise
3.clockwise
CAUTION:
Always check the direction of rotation before
operation. Operate the reversing switch only after
the tool comes to a complete stop. Changing
the direction of rotation before the tool stops
may damage the tool. When not operating the
tool, always set the reversing switch lever to the
center position. (Lock the switch)Never force to
push the switch trigger while the reversing switch
lever is set at the center position.
● Installing or Removing Tools
Tools referred to here include sockets, etc., and are
not equivalent to power tools or machines.
Caution: Always set the reversing switch lever to
the center position before operation and pull out
the battery pack. Never force to push the switch
trigger.
● Installing the tool
To install the socket, insert it into the end the
wrench. Check if the socket is installed on
the tool firmly. The socket is inserted to the
innermost end of the anvil, insert the pin, with a
rubber ring attached to ensure that the socket
does not fall off freely, and it must be checked
that the insertion tool is firmly attached to the
anvil of the machine.