Gazelle GC2034, User Manual, Page: 7 / 12

7
EN
Fig.I
1
2
1. Bolt
2.Socket
CAUTION:
Set reversing switch lever for counterclockwise
rotation when removing the bolt.
● Setting Torque
The machine is provided with 3 gears of torque
adjustment. Touch and press the switch button on
the torque control panel to realize the switch of the
L, M and H gears, so as to adapt to different site
requirement.
L gear: Press the switch trigger and run the tool at
the speed of 1800r/min, the maximum torque can
reach 350N•m.
M gear: Press the switch trigger and run the tool at
the speed of 2100r/min, the maximum torque can
reach 400N•m.
H gear: Press the switch trigger and run the tool at
the speed of 2400r/min, the maximum torque can
reach 488N•m.
CAUTION:
Please use 3 different gears reasonably
according to the usage requirements in different
work occasions.
Fig.J
1
1.Torque Setting
Panel
● Work Light
The white LED work light will be lit when pull the
switch trigger, allows for illumination of the work area
under unfavorable lighting conditions.
Fig.K
1
1.Work Light
● Continuous UseIf the tool is operated
continuously until the battery has discharged, allow
the tool to rest for 15minutes before proceeding with
a fresh battery.
● Operation
For threaded connections with special torque
requirements, use a torque wrench to check
whether the actual torque is in line with the actual
requirements. If it does not meet the actual
requirements, it may become loose in work and
cause personal injury and property loss.
CAUTION:
1. Do not touch the connecting rod during
operation. otherwise the finger may be caught
between the connecting rod and the tool
2. Do not cover vents or you may overheat the
tool and damage it.
3. Please wear the goggles when operating.
4. Please read the operation instructions before
use.
5. Safety protection device
6. Burn hazard: Surface humidity may be high.
CARE AND MAINTENANCE
● Clean the air vents
The vents must be kept clean of the machine. Should
be regular cleaning or clear congestion occurs at any
time.
● Check the mounting screw
Should always check whether mounting screw
fastening safely. If found loose screws, shall be
immediately to tighten, so as to avoid an accident.
● Clean
Do not use liquid such as water or chemical cleaning
agent to clean the machine. Wipe the machine with a
dry cloth.
●
Lubricating
Add lubricating grease to the inner gear housing and
drive spindle for slower wear and better performance
of the tool. And it can also be sent to the designated
maintenance point for professional maintenance.
● Cleaning Charger Base
Cut off power supply and pull out the battery before
cleaning. Use dry cloth to clear dirty and grease
on the charger base. Do not wash it with water or
detergent.
Caution:Always remove the battery pack from the
machine before doing any repair or maintenance
work on the machine.
Inspection and Maintenance
● Inspection
When the machine is sent out or taken back, the