Gazelle GC2030, User Manual, Page: 9 / 16

9
EN
● Tighten screws
Adjust mode switching sleeve to the position ,
place the tip of the driver bit on the screw head and
apply appropriate pressure to the machine. Start the
machine slowly, then gradually increase the speed.
Release the switch button as soon as the clutch is
closed.
Caution: Set the gear position at the low speed.
Make sure that the driver bit is inserted vertically
in the bolt head, or the bolt or the bit may
be damaged. Please choose suitable torque
according to your operational need.
1
2
1.Screw
2.Driver Bit
When tightening wood screws, drill a center hole first
to make tightening action much easier and to prevent
workpiece from sliding. Please refer to the following
table:
Nominal Diameter
of Wood Screw(mm)
Recommended Size of
Center Hole(mm)
3.1 2.0-2.2
3.5 2.2-2.5
3.8 2.5-2.8
4.5 2.9-3.2
4.8 3.1-3.4
5.1 3.3-3.6
5.5 3.7-3.9
5.8 4.0-4.2
6.1 4.2-4.4
● Loosen screws
Place the point of the driver bit in the screw head and
apply pressure to the tool. Start the tool slowly and
then increase the speed gradually. Once the bolt is
taken out, release the switch trigger.
Caution: Set the gear position at the “1” (low
speed). Make sure that the driver bit is inserted
vertically in the bolt head, or the bolt or the bit
may be damaged. Please choose suitable torque
according to your operational need.
1
2
1.Screw
2.Driver Bit
● Spindle Lock
If the switch button is not pressed, the spindle is
locked. Therefore, even if the battery pack is dead,
you can use this machine to screw the screws. That
is, the machine can also be used as a manual tool.
● Overload Protection
The motor stops rotating when overload occurs
during operation. To restart the machine, first release
the switch button to reset the switch, and then turn on
the switch.
INSPECTION AND MAINTENANCE
● Inspection
When the machine is sent out or taken back, the
custodian must make a routine inspection; Before
use, the user must carry out daily inspection; The
unit using the machine must have full-time personnel
to carry out regular inspection; Check at least once
a year; The inspection period should be shortened
correspondingly in hot and humid areas with frequent
temperature changes or in places with poor working
conditions; It should be checked in time before the
plum rain season.
If the machine passes the regular inspection, the
inspection “Qualified" sticker should be pasted on
the appropriate part of the machine. The “Qualified"
mark should be distinct, clear and correct and at least
include: machine number, name or mark of inspection
unit, name or mark of inspection personnel, date of
validity.
● Maintenance
Always adjust the forward reverse switch to the
center position when servicing the power tool,
replacing the tool on the power tool, or carrying the
power tool.
The maintenance of the machine must be carried
out by a maintenance unit approved by the original
production unit. The user and the maintenance
department shall not modify the original design
parameters of the machine at will, and shall not
use substitute materials that are lower than the
performance of raw materials and spare parts that do
not conform to the original specifications.