Gazelle GC2030, User Manual, Page: 6 / 16

6
EN
INTENDED USE
This product is suitable for screwing in and out of
screws under general environmental conditions,
and can also be used for drilling operations on
wood, plastic, metal, walls, etc.
GENERAL DESCRIPTIONS
1.Speed Selector
2.Torque Presetting
Ring
3.Drill Chuck
4.LED Light
5.Switch Trigge
6.Battery Pack
7.Battery Indicator
Light
8.Mode Switch
9.Auxiliary Handle
INSTRUCTIONS FOR OPERATION
● Installing or Removing Battery
Caution:Always switch off the tool and set the
reversing slider to the center position before
install or remove the battery.
The battery pack is only partially charged when
delivered. In order to ensure the maximum power
of the battery, the battery pack must be fully
charged in the charger before the first use.
1.Installing battery pack
As below, when inserting the battery pack, pay
attention to insert the battery pack into the housing
correctly. Be sure to insert the battery pack until you
hear the "click" sound, which means that the battery
pack has been firmly installed on the tool. Otherwise,
the battery pack will accidentally fall off the housing,
causing injuries to the operator or others. Avoid
inserting the battery pack with excessive force or
tapping it in with the help of other objects.
Caution: Only the specified type of battery
pack can be used. The use of battery packs of
other brands carries the risk of injury, personal
injury and property damage due to battery pack
explosion.
1
2
1.Battery Pack
Button
2.Battery Pack
2. Removing battery pack
The battery pack is placed under the machine
handle, press the battery pack button down in the
direction of arrow, and then pull out the battery pack
in the direction of arrow as shown in the figure.
Caution: Don't pull out the battery forcibly!
1.Battery Pack
Button
2.Battery Pack
1
2
●Power Indicator Light
When the battery pack button is pressed or the tool is
started, the light will display the power of the battery,
indicated by the status of the four red LED lights
(hereinafter referred to as red light).
Status of Red LED Lights
Approx. Battery Power
Left
4 lights lit 75%-100%
3 lights lit 50%-75%
2 lights lit 25%-50%
1 light lit 10%-25%
1 light flashed Battery low
1.battery indicator
Light
1
●Continuous Use
If the tool is operated continuously until the battery
has discharged, allow the tool to rest for 15 minutes
before proceeding with a fresh battery.
●Over-discharge Protection
The tool is equipped with a protective circuit to
protect the battery against over-discharging. When