Gazelle GC2030, User Manual, Page: 7 / 16

7
EN
the battery is near to be empty, the protective circuit
actuates to switch off the tool.
●Disposal of Battery
To protect natural resources, please recycle or
dispose of batteries properly. The battery contains
lithium. Consult your local authority for information on
recycling and/or disposal. Remove the battery after
it has run out of power and wrap the pole port with
strong tape to avoid short circuit and leakage. Any
attempt to open or remove any component is strictly
prohibited.
INSTRUCTIONS FOR OPERATION
●Installing or Removing Tool
The tool here includes driver bit, twist drill, etc., which
differs from the concept of power tools or machines.
Caution: Before operation, always set the
reversing switch lever in the central position and
remove the battery. And press the switch button
is absolutely prohibited.
1. Installing Tools
Insert the tool, turn the lock ring of the drill chuck
clockwise (viewed from the front of the machine), and
tighten the tool.
1
4
3
2
1.Front
2.Rear
3.Tool
4.Lock Ring
2. Removing Tools
Turn the lock ring of the drill chuck counterclockwise
(viewed from the rear of the machine) and remove the
tool.
1.Front
2.Rear
3.Tool
4.Lock Ring
1
4
3
2
●Switch Operation
To start the machine, just press the switch button, the
speed of the machine increases with the pressure of
pressing the switch button, and the machine stops
when the switch button is released.
Cautions: Before inserting the battery into the
tool, always check to see that the switch trigger
actuates properly and returns to the “OFF”
position when released.
Do not operate at low speed for a long time,
otherwise the machine may be overheated.
1
1.Switch Button
● Reversing Switch Action
Forward/Clockwise rotation: Depress the reversing
switch lever from side B to side A for clockwise rotation
for drilling and driving in screws (viewed from the rear
of the tool).
Reverse/Counterclockwise rotation: Depress the
reversing switch lever from side A to side B for
counterclockwise rotation for loosening or unscrewing
screws (viewed from the rear of the tool).
Caution: Always check the direction of rotation
before operation. Operate the reversing switch
only after the tool comes to a complete stop.
Changing the direction of rotation before the tool
stops may damage the tool. When not operating
the tool, always set the reversing switch lever to
the center position. Never force to push the switch
trigger while the reversing switch lever is set at
the center position.
1.Reversing Switch
Lever
2.Counterclockwise
Rotation
3.Clockwise
Rotation
1
2
3
● Speed Selection
To shift the gear, first turn off the machine, put the
reversing switch lever in the center position (lock
switch), and then shift the speed selector to "1"
(low speed) or "2" (high speed).Be sure to put the
speed selector in the correct position before using it.
Choose the right speed for your job.
CAUTION:
1. Always keep the speed selector in a proper
position. Set the selector in a position between
the “1” and the “2” may cause damage to the
tool while in operation.
2. Shift operation can be carried out only after
the machine stops completely. Do not push