Gavita HGC906461 Manual Download Page 3

3

Safety recommendations and warnings

 

 Warning! Carefully read the warnings below before using or working with the product! 

     Avertissement! Veuillez lire attentivement les avertissements ci-dessous avant de travailler avec le produit ou de l'utiliser!  

• 

Always adhere to local rules and regulations when installing or using the LED fixture. 

Vous conformer en tout temps à la réglementation locale lors de l'installation ou de l'utilisation du dispositif à DEL.

• 

Do not open or disassemble the LED fixture; there are no serviceable parts inside. Opening or modifying the LED fixture can 

be dangerous and will void the warranty. 

Ne pas ouvrir ou démonter le dispositif à DEL; aucune pièce n'est réparable à l'intérieur. Ouvrir ou modifier le dispositif à 

DEL peut être dangereux et entraînera l'annulation de la garantie. 

• 

This product may cause interference to radio equipment and should not be installed near maritime safety communications 

equipment or other critical navigation or communication equipment operating between 0.45 - 30 MHz. 

Ce produit peut causer des interférences avec l'équipement radio et il ne doit pas être installé près d'équipement de 

communication de sécurité maritime ou d'autres équipements de navigation essentiel ou de communication fonctionnant 

entre 0,45 et 30 MHz.

• 

Do not use the LED fixture when either the LED fixture or its power cord are damaged. Replace the power cord only with 

original, certified cords. 

Ne pas utiliser le dispositif à DEL lorsqu'il est endommagé ou que son cordon d'alimentation est endommagé. Remplacez le 

cordon d'alimentation uniquement avec un cordon original et certifié. 

• 

Modifications to the cords can lead to unwanted electromagnetic effects, which makes the product not comply with legal 

requirements. 

Des modifications aux cordons peuvent entraîner des effets électromagnétiques non désirés, rendant le produit non 

conforme aux exigences légales.

• 

Do not expose the LED fixture to: 

Ne pas exposer le dispositif à DEL:

 

- (ambient) temperatures outside the specified range;

 

- aux températures (ambiantes) au-delà de la plage spécifiée;

 

- dust and contamination;

 

- à la poussière et à la contamination;

 

- direct sunlight during use or HID light that could heat up the ballast.

 

- à la lumière directe du soleil ou à la lumière à DHI pendant l'utilisation, car cela pourrait faire chauffer le ballast.

• 

Always disconnect the LED fixture from mains before performing any maintenance. 

Toujours débrancher le dispositif à DEL du conducteur principal avant d'effectuer tout entretien. 

• 

Always allow for a cool-down period of at least 30 minutes before touching the LED rails. Touching the LED rails when the 

fixture is lit or immediately afterward can result in severe burns! 

Toujours prévoir une période de refroidissement d'au moins 30 minutes avant de toucher les traverses du dispositif à DEL. 

Toucher les traverses lorsque le dispositif est allumé ou immédiatement après l'avoir éteint peut entraîner des brûlures 

graves!   

• 

Do not use the LED fixture near flammable, explosive or reactive substances. Do not use sulfur vaporizers or water misters. 

Ne pas utiliser le dispositif à DEL près de substances inflammables, explosives ou réactives. Ne pas utiliser de pulvérisateur 

de soufre ou de brumisateurs.  

• 

The installation and use of the LED fixture is the responsibility of the end user. Incorrect use or installation can lead to 

failure and damage to the LED fixture. Damage to the LED fixture and electronic circuitry as a result of incorrect installation 

and use revokes the warranty. 

L'installation et l'utilisation du dispositif à DEL sont la responsabilité de l'utilisateur final. Une mauvaise utilisation ou 

installation peut entraîner une défaillance et endommager le dispositif à DEL. Des dommages au dispositif à DEL et aux 

circuits électroniques résultant d'une mauvaise installation et utilisation révoqueront la garantie. 

 

 

 

 

 

 

 

 

 

 

 

 

 

Summary of Contents for HGC906461











Reviews: