S222 & S222.250 & S222.100
|
USER GUIDE
6 | Introduction
Cautions
•
Treat the simulator with the same precautions used with a real patient.
•
Do not attempt to intubate without lubricating the airway adjunct with mineral oil lubricant. Failure to
lubricate the device will make intubation very difficult and is likely to result in damage to the simulator.
•
Mouth to mouth resuscitation without a barrier device is not recommended as it may contaminate the airway.
•
Do not use povidone iodine on the simulator.
CAUTION: The tubing simulating veins is made of latex which may cause allergic
reactions. Users allergic or sensitive to latex should avoid direct contact with
the tubing. Seek medical attention if an allergic reaction occurs.
Storage
•
Store the simulator in a cool, dry place. Extended storage should be between 32 - 85° F (0 -
29° C). Storage above 85° F (29°C) will cause the simulator to soften and slowly warp.
•
Humidity: 40%-60% (non-condensing)
•
Do not stack or store heavy materials on top of the box.
•
Please store and ship in the bag and box provided.
Procedures
•
Do not attempt to intubate without lubricating the airway adjunct with mineral oil lubricant. Failure to
lubricate the device will make intubation very difficult and is likely to result in damage to the simulator.
•
When simulating drug administration via endotracheal tube, providers must use an empty
syringe. Passing liquids into the trachea or esophagus may cause internal damage.
•
Mouth to mouth resuscitation without a barrier device is not recommended, as it will contaminate the airway.
•
Treat the simulator with the same precautions that would be used with a real patient.
Cleaning
•
Remove all traces of lubricant at the end of each simulation session.
•
Remove the fluid using the fill kit provided.
•
Drain all the fluid from the dispensing bag and IV Arm by unclamping the drainage
tube and pumping the squeeze bulb attached to the dispensing bag.
•
Flush the fluid reservoirs and venous system with a 30:70 mix of isopropyl alcohol to water after each
day of simulation then suction all fluid out. You may also fill the dispensing bag with this mixture.
•
The simulator is “splash-proof” but not water proof. Do not submerge in water.
•
The simulator should be cleaned with a cloth dampened with diluted
liquid dishwashing soap. Do not clean with harsh abrasives.
•
Dry thoroughly after every cleaning.
