更新程式
完成後(畫面會顯示)，ESC聲響停止、
接下來點選執行鍵。
此時開始執行程式更新動作(ESC會發出聲響，
MODE會閃紅燈)。
MODE紅燈熄掉，此時先移除機體電源。
接下來移除USB線，完成更新動作。
完成後需重新設定ESC(P.6)及微調校正(P.10)，若有設定雲台也必須重新校正。
Firmware Update
7.Then click “Execute”.
8.The system will start to execute the firmware
updating procedure (the ESCs will come with
sounds, “MODE” LED light turn red and flash).
9.When updating procedures is completed
(as display on PC), sounds of ESCs will stop,
“MODE” LED light will turn off, you should
then disconnect the battery of the 500X.
10.Remove the USB cable, the firmware
updating procedure is completed.
After updating the firmware, you have to reset the ESCs (P.6) and implement the calibration procedures
(P.10) again, if you installed the camera gimbal, you need to recalibrate the camera gimbal again.
25
