User Manual
Page 9
DIA-400S
Input
Standby
DIA-400S
Input
Standby
DIA-400S
Input
Standby
Home Theater direct
HOT warning
OFF warning
Direct
The Direct function bypasses the volume control turning this amplifi er into a fi xed level power
amplifi er. This can be very useful in surround setups. To activate this mode, select input IN1 and
press and hold the Input button on the front panel of the amplifi er for 4 seconds. The left display
will read HT.
To disable the function, press and hold the Input button on the front panel of the amplifi er for
4 seconds. The amplifi er remembers this setting in standby mode and when the DIA-400S is
switched off .
Protection warnings
The DIA-400S is equiped with a sophisticated protection circuit to protect the amplifi er and/or
the connected equipment in case of failure. The DIA-400S features two warning signals:
A
HOT
sign will blink in the right display due to temperature problems:
If this happens, turn off the amplifi er mains switch and wait about 10 minutes for the heat sinks
cool down before turning on the mains again. If a lot of heat is generated within a short period of
time, please check the following:
• The ventilation around the amplifi er
• The speaker cable and cable connections
• The
specifi cations of the connected loudspeakers
An
OFF
sign will blink in the right display:
Turn off the amplifi er mains switch and please check the following before turning the mains on
again:
• The speaker cable and cable connections
• The connected equipment
• That you are not playing above the clipping area of the amplifi er
If the amplifi er keeps blinking after the powering up routine, please turn off the amplifi er and
contact your dealer or the national distributor.
