Instructions for SL500DC/SL800DC
www.gatexpertstore.com
15
Insert the wire into the
number on the terminal that
you are looking to connect to.
Refer to Page 14.
Tighten with a screwdriver
to secure the wire in place.
Terminal Instructions
All changes to these settings below must be completed by licensed electrician.
Wiring to the Terminal
X7 Terminal: (as per Figure 20):
ANT:
Extra Antenna
GND:
Extra Antenna Shield
COM:
Common Terminal for External Push Button
STP:
External Stop Push Button Switch
PED:
External Close Push Button Switch
OSC:
External Open Push Button Switch
X5 Terminal:
IR:
Photocell Input Common Terminal for Photocell(N.C.)
GND:
Ground
12V:
Additional Acces12VDC, after gate closed in place,
the board will enter into low power consumption mode, this
terminal will cut off the 12V power supply.
LAMP+:
Alarm Lamp +12/24VDC
LAMP-:
Alarm Lamp -12/24VDC
Using a screwdriver to
loosen the screw on the
side of the terminal.
