Via Mantova, 177/A - 37053 Cerea (Verona) Italy - Tel. +39 0442 330422 r.a. - Fax +39 0442 331054 - e-mail: [email protected] - www.fadini.net
EUROPEAN MARK CERTIFYING CONFORMITY
TO THE ESSENTIAL REQUIREMENTS OF THE
STANDARDS 98/37/EC
• DECLARATION OF CONFORMITY
• SAFETY NORMS
• EN 12453, EN 12445 STANDARDS
• CEI EN 60204-1 STANDARDS
• WARRANTY CERTIFICATE ON THE CUSTOMER’S REQUEST
The growth of MECCANICA FADINI has always been based on the development of guaranteed products thanks to our “TOTAL QUALITY
CONTROL” system which ensures constant quality standards, updated knowledge of the European Standards and compliance with
their requirements, in view of an ever increasing process of improvement.
The “CE” mark certifies that the operator conforms to the essential requirements of the European Directive art. 10 EEC 73/23, in relation
to the manufacturer’s declaration for the supplied items, in compliance with the body of the regulations ISO 9000= UNI EN 29000.
Automation in conformity to EN 12453, EN 12445 safety standards.
10-2005
IMPORTANT WARNING NOTES
- Before installing the equipment carry out a
Risk Analysis
and fit any required device in compliance with EN 12445 and EN 12453 Safety Norms.
- It is recommended to keep to the instructions here outlined. Check the specifications on the motor sticker with your mains supply.
- Dispose properly of the packaging: cardboard, nylon, polystyrene, through specializing companies.
- Should the operator be removed,
do not cut
the electric cable. This must be properly removed from the terminal board in the junction box.
- Switch off the mains switch before removing the junction box cover where the electric cable is terminated.
- All the system must be earthed by using the yellow/green wire, marked by its specific symbol.
- It is recommended to read the regulations, suggestions and remarks quoted in the booklet “Safety Norms”.
CHECKING AND MAINTENANCE:
To achieve an optimum performance and longer life of the equipment and in observance of the safety regulations, it is recommended that inspections
and proper maintenance are made by qualified technicians to the whole installation ie, both the mechanical and electronic parts, as well as wiring:
- Mechanical parts: maintenance every 6 months approx.
- Eletronic apparatus and safety equipment: maintenance every month.
®
INSTALLATION MANUAL
GB
AUTOMATIC GATE MANUFACTURERS
®
s.n.c.
The manufacturers reserve the right to change the products without any previous
notice and are not liable for possible damages to people and properties.
Distributor’s box
Made in Italy
®
